Baytech ATS Power Switching units 2012 Uživatelský manuál

Page1 2012COPYRIGHT2012BayTechnicalAssociates,Inc.12/1/2012TransferSwitch(ATS)

Page10QUICKSTART:ATS Main Control: For those Administrators who have requested the bare minimum for

Page11DetailOperationsandConfigurations ATS Series (C) 2010 BayTech F1.00 Option(s) Installed: True

Page12HELPOPTIONS Menu 1: Help Configuration Menu To select the configuration menu, type ‘Config” at the prompt. Left screen shot o

Page13 Delete a User Rename a User Select A), to add a user. The unit will prompt for a user name. Type the user

Page14Assigned Outlets Change Outlet Name Enable/Disable Status Menu The Assigned Outlet Menu displays

Page15Change Unit ID Change Alarm Threshold Change ATS Voltage Switching Points Change ATS Switch Back Mode/Time

Page16Change ATS Delay Switch to Secondary Select 8), from the configure menu to allow the user to set the

Page17Display Current Electrical Characteristics: Logging Out Current User Password: Type Power at the

Page18Identify Current User Unit Identification Setting Source Input Primary SETUPOPTIONS ATSSET Default Set Points Loss Of Prim

Page19Voltage Set LOSSPSP RESETPROCEDURE The menu displays the current operating voltage and then asks the oper

Page2TableofContentsCOMPLIANCE STANDARD ...

Page20BAYTECHPRODUCT(US)WARRANTY Exceptions BayTech Extended Warranty Bay Technical Associates

Page21Technical Support Repair Policy BayTech offers Tech Support for the lifetime of the pr

Page22Return Authorization Process 1. Contact BayTech to get a Return Authorization (RA) Number. IMPORTANT: BayTech will not a

Page23TROUBLESHOOTINGProblem: Solution: Reference: Unit Switches Continuously Verify the voltage and frequency is set for the input voltage via A

Page24BracketInstallationHORIZONTAL Mounts: Bracket 1: 1U - M140R115 Bracket 2: 2U - M140R114 Bracket 3: Horizontal

Page3ABOUTTHISBAYTECHOWNER’SMANUAL This document provides information required for installing and o

Page4COMPLIANCESTANDARD CONNECTIONDESCRIPTION EIA-232 Serial Connection ATS CPU BayTech units are in

Page5INSTALLATIONUnpacking Preparing the Installation Site Power Compare the unit and serial number of t

Page6 CAUTION: Do not exceed the AC current rating for the selected model. ATTENTION: Ne dépassez pas l&a

Page7CIRCUIT BREAKER CABLINGRJ-45 Cable Control Module RJ-45 pin Signals Pin EIA 232 Signal Signal Direction Description 1 DTR O

Page8RJ08X007 Standard Rollover Cable RJ45 to RJ45 Figure 2: RJ08X007 Pin Out Figure 3: RJ45 Connector & Plug Adapte

Page9 ATS11 Front, ATS22 similar Front ATS11/ATS22 Rear ATS12 Rear on Top, Front on Bottom ATS23 similar Rear but UL489 Breakers on Front panel