Baytech MMP units controller Reset Procedures Uživatelský manuál stáhnout pdf

ModularControllerResetProcedure



1),Removethe(5)screwfromthe

faceplate,RedArrows

2),UseEXTREMECAUTION:if

powerisappliedtounit,Pull

controllerouttorevealthe

connector,

RedArrow.

Pressthesmalltabincenterof

connectortoreleasethe

connectorfromthecircuitboard.

RedArrow

ProductionControllerresetsteps:ThisstepwillNOTaffectthestateoftheoutlets.

1. Use a paper clip or similar object, Press and hold a micro-switch in the hole next to the (SEL) button

under the LCD screen or between 2

& 3

LED (BLUE Arrow) disconnect the cable to the module for

5 seconds, (RED Arrow)

2. Continue to press micro-switch, connect cable to module, wait 10 seconds and release switch.

3. Serial in to the module. If it appears the controller did not reset, still contains old data, perform reset

again but increase the disconnect time to 10 seconds and wait time to 15 seconds.

Shrnutí obsahu

Strany 1

ModularControllerResetProcedure1),Removethe(5)screwfromthefaceplate,RedArrows2),UseEX

Příbuzné modely MRP units controller Reset Procedures | MSP units controller Reset Procedures |

Komentáře k této Příručce

Žádné komentáře

Baytech MMP units controller Reset Procedures Uživatelský manuál

Procházejte online nebo si stáhněte Uživatelský manuál pro Počítačový hardware Baytech MMP units controller Reset Procedures. BayTech MMP units controller Reset Procedures User Manual Uživatelská příručka

Shrnutí obsahu

Příbuzné modely MRP units controller Reset Procedures | MSP units controller Reset Procedures |

Komentáře k této Příručce